Safety And General Information; Product Description - EQUIPRITE Insta-Lift 5100788 Instrucciones De Funcionamiento Y Manual De Piezas

SaFeTY and GeneRaL InFORMaTIOn

Save these instructions. For your safety, read, understand, and follow the information provided with and on this jack
before using. The owner and operator of this equipment shall have an understanding of this jack and safe operating
procedures before attempting to use it. The owner and operator shall be aware that use and repair of this product
may require special skills and knowledge. Instructions and safety information shall be conveyed in the operator's
native language before use of this jack is authorized. If any doubt exists as to the safe and proper use of this jack,
remove from service immediately.
Inspect before each use. Do not use if broken, bent, cracked or damaged parts are noted. Any jack that appears
damaged in any way, or operates abnormally shall be removed from service immediately. If the jack has been or
suspected to have been subjected to a shock load (a load dropped suddenly, unexpectedly upon it), immediately
discontinue use until jack has been checked by a factory authorized service center (contact distributor or manufacturer
for list of authorized service centers). It is recommended that an annual inspection be done by qualified personnel.
Labels and Operator's Manuals are available from the manufacturer.

PROdUCT deSCRIPTIOn

This Service Jack is designed to lift, but not support, one end of a vehicle. Immediately after lifting, loads must be
supported by a pair of appropriately rated jack stands. This service jack has a unique feature that provides fast, no
load lifts to the jacking point, at which time it lifts in approximately 0.75~0.2" increments.
!
NEVER use hydraulic jack as stand-alone device. After lifting, immediately support the lifted vehicle with
a pair of appropriately rated jack stands. NEVER place ANY portion of your body beneath the vehicle when
lifting OR lowering!
SPeCIFICaTIOnS
Model Capacity
5100788 2-1/2 Ton
5100792 3 Ton
Handle Sleeve
Jack Size (L x W)
29-3/4" x 13-1/4"
31-7/8" x 15-3/8"
Handle
(release valve)
Figure 1 - Typical Service Jack Nomenclature
Min. Height
4"
4"
Oil Filler Vent Screw
(on reservoir)
Lifting Arm
Saddle
Front Wheel
Caster
2
Max. Height Saddle Dia.
20"
5-1/2"
23"