Gauss BT010 Manual Del Usuario página 30

1.5. A high-voltage probe (KV40):
EN
NOTE: The high-voltage probe (KV40) is installed at the
back of the Tester.
1.6. An auxiliary lamp for testing regulators, flasher relays
and others (LA01):
1.7. An auxiliary resistor, for testing Hall type sensors
(RA01):
26
1.8. A wiring harness for regulator testing (RM01):
IDENTIFICATION OF THE REGULATOR TESTING HARNESS (RM01)
TEST TIP
COLOR
COLOR
RED
GREEN
BLACK
YELLOW
ORANGE
BLUE
1.9 A wiring harness for ignition module testing (RM02):
IDENTIFICATION OF THE MODULE TESTING HARNESS (RM02)
TEST TIP
COLOR
COLOR
RED
BLACK
ORANGE
VIOLET
GREEN
BLUE
The testing harnesses are installed at the front of
the equipment, using the corresponding connector. These
are not interchangeable, so there is no possibility of error
in the connection. It is important to note the right position
of the harness connectors. They should enter smoothly. If
you try to connect them in reverse position or force them
in, the connection pins may be damaged.
NOTE: The catalogue of images with detailed testing infor-
mation for each element is available at
www.gauss.com.br/bt010.
Electronic Auto Parts Tester Manual BT010
SYMBOL USED NAME
D+ Triodiode
B+, S, IG Positive from Battery
D- Ground
DF Field
L Lamp
W, V Stator
SYMBOL USED NAME
B+ Positive from Battery
Ground Ground
+ Signal Distributor Signal
- Signal Distributor Signal
Coil Negative from Coil
Sensor Logical Tip