Inspecting The Control Panel - Aramsco Syclone LGR El Manual Del Propietario

DRAINING/WINTERIZING
The unit is equipped with a drain to allow removal of any water
that might remain in the unit after operating the purge function.
Draining the unit is especially important when the unit might be
exposed to freezing conditions during storage or transport.
∕
3
After placing a catch basin under the plug, use a in. wrench
8
to remove the drain plug located in the lower right corner of the
rear panel.
Tip: With the drain plug removed, gently shake the unit
and then tip the unit back and to the right. This will allow
for more complete removal of any water that has collected
in the rear panel.
Once any water has drained out, replace the plug. Tighten until
snug. Do not overtighten.

INSPECTING THE CONTROL PANEL

Using a Philips screwdriver, remove the four baseplate
retaining screws.
Carefully lift out the control panel. The sensor connections
are located on the underside of the panel.
The sensor connections are labeled "OUT T" (outlet
temperature sensor) and "DEFR" (defrost sensor).
Note that the DEFR cable is marked with silver paint. Make
sure each cable is connected in the correct location and that
they are firmly seated.
07-01922C F532-120V 2015-03 Warranty 07-01939 17 Aramsco