Installation Procedure - Boer Temper Koban KDP9 360 mini Manual Del Usuario

KDP9
Mini presence detector

Installation procedure

NOTE
To secure correct wiring, please verify
it carefully after wiring.
Drill a hole with diameter of 32mm
on movable ceiling board for
detector head installation (See
FIG.10), then select a desired place
on movable ceiling board and keep
the power cable outside. Please strip
off 6 - 8mm of cable sheathing for
wiring (See FIG.11).
Φ=32
Drill a hole with
Φ=32mm on
the ceiling
FIG.10
Ceilingboard removed
FIG.11
Φ=32
Max.6m
FIG.12
Instructions manual |
6 - 8mm
Φ=32
22
NOTE
During installation, all the
requirement of mentioned standard
must be fulfilled when installing,
also insulation and requirements of
interconnection cord between
power box and detector shall be
considered.
Keep the installation distance
between two detectors max. 6m (See
FIG.12) if additional OS-459S is
connected to KDP9 power box, and
ensure the thickness of ceiling board
is 5 - 20mm (See FIG.17).
Unscrew protection cover on power
box with screwdriver. RJ-12 sockets
are for detectors connection and
terminals are for power and load,
then put the protection cover back
and screw it tightly (See FIG.13).
Protection cover
Non-dropping
Screw
Detector side
RJ-12 socket
Knock-outs on bottom case and
protection cover are for different
cables entry size:
www.grupotemper.com
Non-dropping
Screw
Power supply
and load side
FIG.13