Panasonic TY-CE103PS10 Instrucciones De Instalación página 20

Soporte para colgar en el techo la pantalla de plasma
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 58
Assembly
5. Install the frame.
The display can take an angle of 5, 10, 15 or 20 degrees to the
vertical plane.
Which assembly holes in the columns are to be used depends on
the angle at which the display is to be installed.
1. Place one frame, assembled in the previous page, on each
column, and fasten one end of the frame with one prepared M16
bolt
.
2. Identify the hole corresponding to a desired angle, and fasten the
other end of the frame with one prepared M16 bolt
• The bolt should be securely tightened to the torque given
below.
25~35 N•m
6. Install the joint.
Install the joint
1. As shown in the figure below, align the holes of the joint
mm)
from the outside.
2. Put the nuts
• The bolt should be securely tightened to the torque given below.
12~14 N•m
20
(Inclined hanging)
onto the left and right frames.
in from inside the frame, and fasten them with the M8 bolts (20 mm)
2
1
Prepared M16 bolt
.
10°
15°
20°
with those of each frame, and insert M8 bolts (20
2
1
2
.
1

Publicidad

Tabla de contenido
loading

Tabla de contenido