Vinylexpress Q Serie Guía De Usuario página 247

4.10 Now, you are ready to print and cut with your Q Series vinyl cutter. Click the Send button at the bottom of the General tab.
This will send the raster and vectora data to the LXI RIP 19 Production Manager. The raster data will be sent to the printer queue and the
vector data will be sent to the cutter queue. The print queue will begin to RIP and print the image. The vector data will be held in the cutter
queue until the print is completed.
4.11 Once the print job is finished, remove the printed image from the printer. Take care to advance the media far enough to leave
at least 2 inches (5cm) of space between the top registration marks and the edge of the media. Place the print on the Q Series cutter,
facing the same way it came off the printer. As directed in section 13.4.2, move the cutter blade to the center fo the lower
right registration mark and set that as the origin point on the Q Series cutter's control panel. Then return to the PC, find the job holding
in the LXI RIP Production Manager queue and click Send. Production Manager will remind you to set the Origin Point in the lower right
regisration mark. If you have aleady done so, click OK.
MARK TYPE 1
Move here
The Q Series cutter will begin scanning the marks.Contour-cutting will begin automatically once the marks have been scanned.
If you have selected the Graphtec Segment Area option, the cutter will scan the lower four registration marks, then cut all the
vector paths in that segment. Then it will scan the next segment and cut those paths, and continue in this manner until the job is
completed.
MARK TYPE 2
Move here