First Commissioning; Keypad - Majestic UNO Instrucciones De Uso

3. ELECTRONICS UNIT

3.1. First commissioning

When switching on the electronics unit for the first time, carry out the following programming.
Successive
menus
• Français
• English
• Deutsch
Langues • Español
FRANCAIS
• Italiano
• Nederlander
• Portugués
Volume
From 10 to 200 m
50 m3
Date
Day / Month / Year
01/01/01
Time
Hour / Minute
XX:XX
• In line
Display
• Dashboard
In line

3.2. Keypad

COMMAND KEY
(depending on
model)
• Switching on the electronics unit.
→ A few minutes after switching on, production starts automatically (with or without ORP
• Switching off the electronics unit (press and hold).
MENU
→ When switching off, the screen and the green LED turn off while the red LED comes on.
→ If an alarm has been activated, press first on
• Access the menus.
Boost mode starts for 24 hours.
BOOST
• Water temperature display for a few seconds (only if the default display is set to « In line
display »).
T°C
• Direct access to the «
• Salt level display for a few seconds (only if the default display is set to « In line display »).
SALT
• Direct access to the «
→ This command key is only present on the DUO and PRO models.
pH
• Direct access to the «
Selecting a value or data element.
• Cancellation of an entry
• Back to previous menu.
• Stopping Boost mode.
• Command confirmation.
• Entering a menu.
OK
• Dismissing an alarm.
Possible settings
3
, in increments of 10.
check).
Parameters - Temp. Adjust
Parameters - Salt Adjust
pH Regulation - Calibration
Navigation
For each parameter, select a data item with the
buttons, then confirm with the OK button.
FUNCTION
to switch off.
» menu (press and hold).
» menu (press and hold).
» menu (press and hold).
4