Yamaha YTS-V1100 Manual De Instrucciones página 11

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 55
■When using the TV mounting bracket + mounting adaptor
10. Taking care not to damage the TV, spread a soft
cloth on a level surface and carefully lower the TV
screen down onto it. Then remove the table-top
stand from the TV.
To remove the stand, unscrew the
screws that fasten it to the TV.
Blanket or
other soft cloth
The method used for removing the table-top stand, the location and
Caution
number of screws and method of handling the TV will vary depending
on the TV model. Be sure to refer to the TV' s user' s manual.
If you anticipate using the table-top stand again, you will
Caution
need the table-top stand mounting screws, so store them
carefully with the table-top stand so they are not lost.
12. Fasten the mounting adaptor with the four TV mounting screws.
Mounting adaptor
Upper (large):
M8 screws
Lower (small):
M5 or M6 screws
The size and/or installation position of TV mounting screws may vary with
Caution
the model, so check them prior to installation. If a mistake is made in
installing the screws, it may damage the hardware and/or cause injury.
Screw sizes
■Positioning of the mounting adaptor with the TV mounting bracket
500 (W) x 200 (H)
500
Table-top stand
mounting screws
Table
Table-top stand
(F) M5 x 16 ... small hole
(G) M6 x 14 ... small hole
(H) M6 x 20 ... small hole
( I ) M8 x 20 ... large hole
400 200
400 300
400 400
400
11. Wire all cabling to the TV and remove the four
screws for wall-mounting the TV from its rear.
(Refer to the TV' s user' s manual for information on
connecting cables to your TV.)
Screws for
wall mounting
The location of screws that need to be removed from the
Caution
back will vary with the model of TV. Be sure to refer to
the TV' s user' s manual.
Check the size of the TV mounting screws in your user' s
manual under the section for mounting your TV on a wall.
If this information is not listed, find the appropriate screw by
mating the TV mounting bracket to your TV and gently trying
the screws in order from the shortest and smallest screw up
to longer and larger screws. While doing so, if it feels like the
tip of the screw has run into something, immediately stop
screwing the screw in any further.
300 300
300 200
300
7 En
Screws for
wall mounting
Caution
Install the mounting adaptor
parallel to the vertical axis of the
TV. If it is not installed parallel, it
will slant when it is attached to
the support column.
200 200
200
If the size is 200 x 200,
Caution
shift the mounting
adaptor left-right to
attach it.

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido