rcf L-PAD 12C Manual Del Usuario página 7

FUNCTIONS
HOW TO GET SOUND FROM A RCF MIXER
1. Turn your RCF mixing consoles mixer on.
2. Set all the faders and controls to minimum position (0 or
‑∞)
3. Plug a microphone into the XLR connector ‑ MIC input of
channel 1.
4. Connect your speaker system to the MAIN MIX output and
turn it on.
5. Press the PFL button. Sing into the microphone and adjust
the GAIN control until the OUTPUT LEVEL is shown by means of LEDs (all green LEDs should light up and the first yellow LED should do so
occasionally).
6. Press again the PFL button to cancel the operation.
7. Adjust the FADER up to "0" position.
8. Check whether the MUTE button is in released (UN‑MUTED channel).
9. Press the L‑R button to route the channel signal to MAIN MIX.
10. Carefully turn up the MAIN MIX fader to reach a reasonable sound level.
11. Enjoy the quality of your RCF mixing consoles mixer.
HOW TO IMPROVE THE SOUND
The RCF mixing consoles mixer implements several
powerful tools to improve the sound quality of your
music even more.
COMP: Turn the COMP control clockwise to add a compression effect to the signal. This allows to control the dynamic of the signal, limiting peaks and
gaining level in case of low signals.
EQ: A three‑band EQ is available on each mono channel, while a dual‑band
EQ is available on stereo channels 9‑10 and 11‑12. Adjust these parameters to
subtract noise frequencies or magnify desired sounds.
7