GUITAR/BASS AUTO TUNER
YT-150
YT-150
OWNER'S MANUAL
Thank you for purchasing the YAMAHA YT-150 Guitar/Bass
Auto Tuner.
Please read this manual thoroughly and keep it in a safe place for
future reference.
I PRECAUTIONS
N To prevent damage, do not use the tuner in the following locations:
• places where the unit will be in direct sunlight;
• places subject to temperature and humidity extremes;
• places that are sandy or dusty.
N To power the tuner, use only a 6F22 or 006P 9V dry cell battery.
N For maximum battery life, always be sure the tuner is turned OFF when not in
use.
N If an exhausted battery is left in the unit for an extended period of time, it may
leak and cause malfunctioning of the unit. When the battery becomes
exhausted, always remove it and replace it as soon as possible.
N Do not subject the tuner to strong physical shock or vibration. Do not use
excessive force on any of the controls.
N Never use solvents such as benzene or thinner to clean the tuner. Wipe clean
with a soft, dry cloth.
N After reading the owner's manual, keep it in a safe place for future reference.
Never dispose of used batteries by burning them.
Also make sure to keep batteries away from children.
I BATTERY REPLACEMENT
When battery power runs down, the
LCD indicator will grow dim.
Continued use of the tuner may result in
inaccurate operation. Replace the
battery with a new one (6F22 or 006P
9V dry cell battery) as soon as possible.
The battery compartment is in the rear
of the tuner. Remove the old battery
and replace it with a new one of the
same type. Be careful to connect the
battery in the correct polarity.
u
* Always turn the POWER switch
I SPECIFICATIONS
Indicators
: Liquid crystal display, Tuning guides
Tuning Notes
: GUITAR
BASS
Note Setting Range
: A0 (27Hz) – C8 (4186Hz)
: ±1 cent
Accuracy
: ±3 cent
In Pitch Accuracy
Standard Pitch Setting Range
: A4=435 – 446Hz (1Hz steps)
Input
: INPUT (6
Output
: OUTPUT (6
Power Source
: 9V dry cell battery (006P or 6F22)
Battery Life
: Approximately 50 hrs. (AUTO mode)
Dimensions (W x H x D)
: 118 x 63 x 24.5 mm (4.6" x 2.5" x 1.0")
Weight (including battery)
: 130 g (4.6 oz)
Accessory
: 9V dry cell battery (6F22) x 1
* Specifications and external appearance are subject to change without notice.
FCC INFORMATION (U.S.A.)
1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!
This product, when installed as indicated in the instructions contained in this manual,
meets FCC requirements. Modifications not expressly approved by Yamaha may void
your authority, granted by the FCC, to use the product.
2. IMPORTANT:
When connecting this product to accessories and/or another product
use only high quality shielded cables. Cable/s supplied with this product MUST be used.
Follow all installation instructions. Failure to follow instructions could void your FCC
authorization to use this product in the USA.
3. NOTE:
This product has been tested and found to comply with the requirements listed
in FCC Regulations, Part 15 for Class "B" digital devices. Compliance with these re-
quirements provides a reasonable level of assurance that your use of this product in a
residential environment will not result in harmful interference with other electronic de-
vices. This equipment generates/uses radio frequencies and, if not installed and used
according to the instructions found in the users manual, may cause interference harmful
to the operation of other electronic devices. Compliance with FCC regulations does not
guarantee that interference will not occur in all installations. If this product is found to
be the source of interference, which can be determined by turning the unit "OFF" and
"ON", please try to eliminate the problem by using one of the following measures:
Relocate either this product or the device that is being affected by the interference.
Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or
install AC line filter/s.
In the case of radio or TV interference, relocate/reorient the antenna. If the antenna
lead-in is 300 ohm ribbon lead, change the lead-in to co-axial type cable.
If these corrective measures do not produce satisfactory results, please contact the
local retailer authorized to distribute this type of product. If you can not locate the
appropriate, please contact Yamaha Corporation of America, Electronic Service Divi-
sion, 6600 Orangethorpe Ave, Buena Park, CA 90620
The above statements apply ONLY to those products distributed by Yamaha
Corporations of America or its subsidiaries.
持込修理
品 名 / 品 番
ギター/ベースオートチューナー/YT-150
保 証 期 間
本体:お買上げの日から1ヶ年間
※お買上げ日
年 月 日
ご住所 〒
お
客
様
お名前
電 話
店
名
印
※
販
住
所
売
店
電
話
ご販売店様へ ※印欄は必ずご記入してお渡しください。
Battery cover
Bottom
side
6F22 or 006P
9V dry cell battery
to "OFF" before changing the battery.
E, A, D, G, B, E
B, E, A, D, G, C
monaural), microphone
monaural)
様
(
)
(
)
I COMPONENTS
q
e
MODE switch
I TUNING PROCEDURES
G Auto Tuning : AUTO
The tuner will automatically select the closest note name (string name) to the
plucked string's pitch.
1. For electric guitars/basses, connect the guitar cable to the INPUT jack o.
(The OUTPUT jack i can also be connected to an amplifier. The guitar's
signal will be sent to the amp whether the tuner's power is switched ON or
OFF. However, it might result in added noise to the line so you should
switch the tuner's power OFF during performance.)
* The built-in microphone y will not operate when a cable is plugged into the
INPUT jack o.
2. Turn the POWER switch u ON.
The standard pitch (factory preset A=440Hz) will flash on LCD indicator q
for about 2 seconds. After that, the tuner will enter the auto tuning mode
(GUITAR and AUTO will appear on the LCD indicator q).
3. Use the PITCH switch r to change the standard pitch. (Refer to the
"Setting the Standard Pitch" section below.)
4. Press the MODE switch e to select the instrument to be tuned. GUITAR or
BASS will appear on the LCD indicator q.
5. To tune an acoustic guitar, place the tuner's internal microphone y as
close as possible to the guitar's sound hole.
6. Pluck the string to be tuned. (Do not pluck more than one string at a time.)
The appropriate string name will appear on the LCD indicator q. Use the
needle and the tuning guide w as a reference while tuning the instrument.
6-1. First, adjust the string so that the appropriate string name indicator
flashes.
6-2. Next, tune the string until the needle rests in the middle and the green
LED of the tuning guide w lights.
example) To tune the "E" string on a six string guitar.
Select GUITAR on
the LCD indicator.
Select the AUTO
mode.
The string name of the
plucked string flashes.
G Manual Tuning : MANL.
Each note must be selected individually as needed.
1. Carry out the same settings as described in steps 1 through 5 of the Auto
Tuning section.
2. Continue to press the NOTE switch t until the desired note name (string
name) flashes. The tuner is now in the manual mode, MANL. appears in
the bottom left hand corner of the LCD display q.
3. As in step 5 of the Auto Tuning section, pluck the string to be tuned and
proceed to tune the string.
4. Repeat steps 2 and 3 to tune other strings.
I SETTING THE STANDARD PITCH
1. Turn the POWER switch u ON. The pitch is set to 440 Hz (flashing
display).
2. Continuously press the PITCH switch r until the desired standard pitch
(435 – 446Hz) is selected.
435→436→437→438→439→440→441→442→443→444→445→446
3. When the PITCH switch r has not been pressed for about 2 seconds, the
tuner will automatically return to the tuning mode.
* When the POWER switch u is turned OFF, the standard pitch setting will be
reset to A=440Hz.
I TILT SLIT
The tuner can be tilted back by using the slit in the rear panel. Insert a coin or
similar flat object into the slit and tilt back as shown in the diagram below.
THIS DIGITAL APPARATUS DOES NOT EXCEED THE "CLASS B" LIMITS FOR RADIO
NOISE EMISSIONS FROM DIGITAL APPARATUS SET OUT IN THE RADIO INTERFER-
ENCE REGULATION OF THE CANADIAN DEPARTMENT OF COMMUNICATIONS.
保証書
この度はヤマハ・ギター/ベースオートチューナーをお買上げ戴きまして
ありがとうございました。
本書は、本書記載内容で修理を行なう事をお約束するものです。お買上げ
の日から左記期間中に故障が発生した場合は、本書をご提示の上お買上げ
の販売店に修理をご依頼ください。 (詳細は裏面をご覧ください)
修理(サービス)メモ
年 月 日
内 容
〒430-8650 静岡県浜松市中沢町10番1号
w
Tuning guide
y
LCD indicator
Built-in microphone
MIC
t
NOTE switch
r
PITCH switch
Tune until needle comes to
rest in the center.
When this LED lights,
the string is tuned.
担 当 者
印
弦打楽器事業部 国内営業部
ギタードラム営業課
TEL 053-460-2433
u
POWER
switch
i
OUTPUT
jack
o
INPUT
jack
Standard Pitch is
displayed.