Troubleshooting Guide; After Sales Service Information - TOFO 330 Manual Del Usuario

3. Trouble Shooting Guide
Problem
Machine has no
power or rollers are
not rolling.
Excessive noise
Bad lamination
No increase of
Temp.
Frequent curling
of film
Corner is not
sealed
Emergency state

4. After Sales Service Information

If you have any problem can't be solved at your end, please contact;
The telephone number is on the label on the back side of machine:
Office Distribution spa – Via Cassino D'alberi, 21 – Tribiano (MI) – 02 91 00 00 01
Cause
●
Power code is not properly
plugged in
●
Power switch off
●
Operation of gear is not
smooth.
●
Laminated document
wrinkled, damp, or folded
●
Check power plug
● Firstly, check the film was
cut off or the un-adjoined
side was inserted first.
● Secondly, check
the cleaning of rollers.
●
Document is too thick to
seal the edges of the film
●
Something may be stuck
Between the heated rollers
or they are out of position
Solution
●
Check the power plug is
properly plugged
●
Check the power switch is
turned on or contact support
●
Turn off the machine, and
then contact A/S
●
Adjust the000 temperature
lower or higher
●
Check if the power plug and
switch is turned on or contact
support
● Insert film by the
sealed direction.
● Clean the rollers
regularly.
●
Use a thinner document or
leave more around the edges,
aprox. 5mm
● Turn off the switch.
Contact A/S