Sani-tip 122230N Manual Del Usuario página 3

ADAPTER INSTALLATION INSTRUCTIONS
1
1. Remove existing thumb
nut and syringe tip.
2
2. Use enclosed hex key,
or appropriate tool to
remove existing adapter
from syringe.
3
3. Verify new adapter
has o-rings
position as shown.
USER INSTRUCTIONS
n
o p
and in
1
1. With thumb nut loosened, insert new Sani-Tip
adapter as far as possible. While still pushing inward, twist tip 1/2
turn clockwise to create a watertight seal over internal tapered water
spindle.
2 2. Hand tighten thumb nut. To redirect tip, push in on tip while rotating
clockwise.
TEST PRIOR TO EACH USE: Express water, then express air only.
If air contains moisture, or tip dislodges, refer to Troubleshooting sec-
tion.
3. To replace tip, loosen thumb nut. Remove and discard used tip.
Repeat steps 1 and 2.
4
4. Hand-thread adapter
into syringe. Use
hex key provided to
tighten.
5
m
5. Verify o-ring is
in place inside large
opening of white
l
plastic cone .
6. With o-ring in place,
6
firmly snap large end
of white plastic cone
over adapter rim.
7. Hand-thread thumb
7
nut onto adapter. Do
not tighten until new
tip has been inserted.
Installation is complete.
and push into
®
3