Unit Identification; Wear And Tear - m-cro MICRO EXPLORER Manual Del Usuario

WARNING
● Make sure only to charge the battery with the enclosed charger and only at
temperatures between 5° and 25° Celsius.
● Follow the safety instructions on the battery.
● Never charge the battery unattended.
● When charging the battery, ensure proper plug connection, adequate ventilation
and a dry environment.
● Never bring the charger, the mains and connection cables into contact with water
as this may cause an electric shock. Do not touch the battery and charger with wet
hands.
● Check the connecting plug and charger at regular intervals. If there is any damage,
have them replaced.
● Always store the battery at temperatures between 5° and 25° Celsius.
● Keep the battery out of reach of children and animals at all times.
● Any repairs and maintenance of the battery or charger must be carried out by a
specialist.
WARNING
● Incorrect tightening of screws may lead to material fatigue. Screws become soft
when they are subjected to excessive stress and may tear. This increases the risk of
accidents and injuries. Always use a torque spanner to tighten the screws.
● Always consult a specialist for repairs to the drive system.
EN
10
for using the battery
for setup, maintenance and repair
INSTRUCTIONS FOR USE

Unit identification

● The serial number is found on the front right side of the deck.
xxxxxxxxxxxx
● More information about your scooter can be found on the adhesive label affixed to
the scooter.

Wear and tear

Use of the electric scooter results in a natural wear and tear process. To ensure safe
riding at all times, please read the chapter 'Maintenance', observe the maintenance
intervals and have them recorded in the service record by an authorized service centre.
Furthermore, follow the instructions in the 'Before each trip' section, each time you
start up your electric scooter.
11