AEG PROFI-FOEN HTD 5616 Instrucciones De Servicio página 21

Ocultar thumbs Ver también para PROFI-FOEN HTD 5616:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
WARNING:
and by persons with reduced physical, sensory, or mental ca-
pabilities or lack of experience and knowledge proved they
do so under supervision or have been given instructions on
how touse the appliance safelyand understand the hazards
involved.
Children must not play with the appliance.
children, unless they are supervised.
mains after use as nearby water presents a hazard. This also ap-
plies if the appliance is switched off.
Danger of ire
fault current protection device (FI/RCD) with a rated current of
not more than 30 mA in the wiring system of the bathroom.
Please contact an authorised electrician for advice.
Commissioning
1. Applicare eventualmente un ugello.
low of hot air with the hairdressing nozzle.
without losing volume.
2. In order to replace the attachment, irst remove the old
attachment by pulling it off and then pushing on the new
one until it clicks into place.
Electrical Connection
the mains voltage to be used matches that of the device.
socket.
user maintenance must not be carried out by
Use
1. Turn the appliance on with the bottom switch on the
handle.
2. Select an air stream level on the handle (bottom switch):
Position 0:
off
Position :
gentle stream of air
Position
:
strong stream of air
3. Setting the Temperature level (top switch):
Position :
low temperature
Position :
Eco: Environmentally friendly energy
saving setting, medium temperature for
gentle drying and shaping.
Position :
high temperature for rapid drying.
English
21

Publicidad

Tabla de contenido
loading

Tabla de contenido