Choose Your Connection; Connecting A Vcr; External A/V Source Setup; Conmponent Setup - Haier HL19R1 Manual Para El Usuario

Installation

Choose Your Connection

There are several ways to connect your television,
depending on the components you want to connect
and the quality of the signal you want to achieve. The
following are examples of some different ways to
connect your TV with different input sources.

Connecting a VCR

To avoid picture noise (interference), leave an adequate
distance between the VCR and TV.
1
2
Connection Option 1
Set VCR output switch to channel 3 or 4 and then tune
the TV to the same channel number.
Connection Option 2
A
Connect the audio and video cables from the VCR's
output jacks to the TV input jacks, as shown in the
figure. When connecting the TV to VCR, match the
jack colors (Video = yellow, Audio Left = white, and
Audio Right = red). If you connect a S-VIDEO output
from VCR to the S-VIDEO input, the picture quality is
improved; compared to connecting a regular VCR to
the Video input.
B
Insert a video tape into the VCR and press
the VCR. (Refer to the VCR owner's manual.)
C
Select the input source with using the
on the remote control, and then press
to select the source, press ENTER button to confirm.
EN-9 TV LCD-TFT Owner's Manual
All manuals and user guides at all-guides.com
VCR
PLAY on
INPUT button
/ button

External A/V Source Setup

How to connect
A
Connect the audio and video cables from the
external equipment's output jacks to the TV input
jacks, as shown in the figure.
B
When connecting the TV to external equipment,
match the jack colors (Video = yellow, Audio Left =
white, and Audio Right = red).
How to use
A
Select the input source with using the
on the remote control.
B
Operate the corresponding external equipment.
Refer to external equipment operating guide.
Component Setup
How to connect
A
Connect the DVD video outputs (COMPONENT) to
the Y Pb Pr jacks on the TV and connect the DVD
audio outputs to the YPbPr Audio IN jacks on the TV,
as shown in the figure.
B
If your DVD only has an S-VIDEO output jack, connect
this to the S-VIDEO input on the TV, as shown in the
figure.
Note
If your DVD player does not have
component video output, use S-Video.
INPUT button