Youin KILIMANJARO BK4000 Manual De Usuario página 26

8. LCD Display
· Walk Speed setting
Walk Speed refers to push-assist mode speed. The settable range is 3-6 km/h. 3km/h
is the slowest while 6km/h is the fastest. The default push-assist speed is decided
by the controller. Press UP/DOWN to increase or decrease the speed limit to your
desired value. Hold the ON/OFF button 1s to confirm and exit the settings status.
· Password (Password refers to the display power-on password.)
Press UP/DOWN button to choose 'Password' and ON/OFF to confirm. Meanwhile
press UP/DOWN button to choose 'Start Password' and press ON/OFF to confirm.
Press UP/DOWN to shift from 'OFF' to 'ON'.
· Power-on password enable
In "Start Password" interface, choose 'ON' and press ON/OFF to confirm. Meanwhile,
display interface asks for a password. Press UP/DOWN button to increase or decrease
numbers and press ON/OFF to confirm the first digit and move to the next digit.
After 4 digits of a password are input, press ON/OFF to confirm and the interface
will prompt for re-entering the password. If two inputs are consistent, the system
prompts that the password is set successfully. If two inputs are inconsistent, the
first input needs to be repeated correctly and confirm the new password again. The
interface will be redirected to original settings page in 2 seconds after the password is
set successfully. Hold ON/OFF to return to the home page or by route 'BACK' →'home
page' .
26
YOU-RIDE KILIMANJARO