Instruction Manual; Intended Use; Power Supply - Makita MLS100 Manual De Instrucciones

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Blade diameter
Hole diameter
Max. kerf thickness of the saw blade
No load speed
Dimensions (L x W x H)
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Cutting capacities (H x W) with blade 255 mm in diameter
Symbols
The followings show the symbols which may be used
for the equipment. Be sure that you understand their
meaning before use.
Read instruction manual.
DOUBLE INSULATION
To avoid injury from flying debris, keep
holding the saw head down, after making
cuts, until the blade has come to a com-
plete stop.
Do not place hand or fingers close to the
blade.
Always set SUB-FENCE to left position
when performing left bevel cuts. Failure to
do so may cause serious injury to operator.
Only for EU countries
Due to the presence of hazardous compo-
nents in the equipment, used electrical and
electronic equipment may have a negative
impact on the environment and human health.
Do not dispose of electrical and electronic
appliances with household waste!
In accordance with the European Directive on
waste electrical and electronic equipment and
its adaptation to national law, used electrical and
electronic equipment should be collected sepa-
rately and delivered to a separate collection point
for municipal waste, operating in accordance with
the environmental protection regulations.
This is indicated by the symbol of the crossed-
out wheeled bin placed on the equipment.
For all countries other than
European countries
For European countries
Bevel angle
0°
45° (left)
610 mm x 485 mm x 515 mm
0°
75 mm x 130 mm
48 mm x 120 mm

Intended use

The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed.

Power supply

The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-3-9:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
8 ENGLISH
MLS100
255 mm
25.4 mm or 30 mm
(country specific)
30 mm
3.2 mm
-1
4,200 min
13.8 kg
/II
Miter angle
45° (left and right)
75 mm x 90 mm
48 mm x 90 mm
) : 89 dB(A)
pA
) : 102 dB (A)
WA