Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Original rubber mounting size is Ø 46.5mm
It is not possible to install the rubber mounting
without compressing.
Use the tool (10) to compress rubber mounting till or
less Ø 45.3 mm, in this way you can install it ,or it
may cause rubber mounting damaged.
Installation with the tool (7)
With bevel design, it can step a side from brake
disk, and the rubber mounting can be installed
easily.
Step 2
Installing new rubber mounting
Insert rubber mount in by special tool No. 10.
Set in position and tighten.
Step 3
Draw rubber mounting with special tools
6 - 7 - 8 - 9 - 10 into wheel carrier. (Fig 4)
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Fig.4
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
9
8
6
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
10
7
Publicidad
Tabla de contenido
