Intended Use - Makita DA330D Manual De Instrucciones

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Drilling capacities
No load speed
Overall length
Rated voltage
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2014
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridge(s) and charger(s) listed above may not be available depending on your region of residence.
WARNING:
Only use the battery cartridge(s) and charger(s) listed above. Use of any other battery car-
tridge(s) and charger(s) may cause injury and/or fire.

Intended use

The tool is intended for drilling in wood, metal and plastic.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-1:
Model DA330D
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
Model DA331D
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
NOTE: The declared noise emission value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE: The declared noise emission value(s) may
also be used in a preliminary assessment of exposure.
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the tool is
used especially what kind of workpiece is processed.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (tak-
ing account of all parts of the operating cycle such
as the times when the tool is switched off and when
it is running idle in addition to the trigger time).
Steel
Wood
) : 70 dB(A) or less
pA
) : 70 dB(A) or less
pA
DA330D
298 mm
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841-2-1:
Model DA330D
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model DA331D
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
NOTE: The declared vibration total value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE: The declared vibration total value(s) may also
be used in a preliminary assessment of exposure.
WARNING:
The vibration emission during
actual use of the power tool can differ from the
declared value(s) depending on the ways in which
the tool is used especially what kind of workpiece
is processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
4 ENGLISH
DA331D
10 mm
12 mm
-1
0 - 800 min
310 mm
D.C. 10.8 V
1.1 kg
BL1013
DC10WA
2
) : 2.5 m/s or less
h,D
2
2
) : 2.5 m/s or less
h,D
2