Kinderkraft BEA Manual De Uso página 24

4. Connecting rail
4A. Connecting rail
5. Side support
2. Assembly
Prepare a suitable surface so as not to damage the product during assembly. Insert the legs (9) into
the main tubes of the cot. If the assembly is correct you will hear a characteristic sound (fig. A). Note:
The holes for the legs protrusions are located on the inner part of the cot legs. Pull the cot body
upwards to put the legs apart (fig. B). Insert the connecting rails (4) (4A) into the tubes between the
leg and the fabric of the cot (fig. C). A characteristic sound will indicate correct assembly. Note: The
connecting rails as well as the tubes between the legs are marked with the letters R and L. For a
correct assembly of elements, the connecting rails and the tube must have the same letter. Put the
upper rail (2) between the legs of the cot in the space provided for this purpose in the central part
of the legs (fig. D). Stretch the legs to make this possible. Insert the lower rail (3) between the legs
of the cot in the bottom part of the legs (fig. E). Connect the central support (5) with the side support
(6). A characteristic sound will indicate the correct assembly (fig. F). Connect the frame with the
connecting rails already attached to the cot (fig. G). Hide the side support (6) in the fabric pocket of
the cot. Wrap the supporter with five hook and loop fasteners on the bottom of the cot and fasten
them together. (fig. H) Put the mattress (8) in the cot.
2.1. Adjustment
The cot has 7-step height adjustment. In order to set the desired height press buttons 1 and 2 (fig.
M) on both legs. At the same time raise/lower the cot.
3. Co-sleeper cot assembly
Press the button in the zip fastener protection and pull it apart (fig. I). Undo the zip fasteners on both
sides of the cot (fig. J), tuck the zip fastener clasp into the pocket in the central part of the cot. To
pull the tube out of the panel push the protective piece under the fabric of the cot and lift the tube
(fig. K). Repeat this action on the other side. Pull the tube out of the side panel. The side panel should
hang freely (fig. L). In order to set the desired height of the cot see chapter 2.1. Connect buckles at
the end of the belt (9) with the buckles on both sides of the cot (fig N). Thread the belt through the
bed frame, mattress or across the bed, and fix the belt with the buckle (fig O). Adjust the straps so
that the cot is securely fixed to the parent's bed. ATTENTION: The upper railing of the cot must be 2
cm lower than the mattress of the parents' bed! (Fig. P) The cot must adhere to the mattress of your
parents' bed! Do not use the cradle function when the cot is used as the co-sleeper!
4. Removing the cover
Take the mattress out of the cot. Undo the zippers on the sides of the side panel, take the tube out
of the side panel. Unfasten the hook and loop fasteners connecting the bottom of the cot and the
support. Undo the zip fastener under the upper railing of the cot. (fig. R) and pull off the cover.
9. Legs x4
24