Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting the system
The following sequence must be exactly followed in order to ensure the proper functioning
of the system:
1. Connect power supply connector with the vehicle.
The LED display (1) "power supply connection" must light up.
If the display does not light up, the socket is not equipped with a permanent 12 V
power supply on the vehicle side.
In this case, use the OBD adapter 8PE185103-321 (accessories)
2. Insert mains cable.
The LED display (2) "Mains connection" must light up.
10
3. If, after connecting, the LED display (3) lights up, the system is in warning mode.
Preset reset button (4) to reset the system. The system is now ready for operation.
Disconnecting the starter battery
•
First, disconnect the negative pole of the battery.
•
Disconnect the positive pole if the battery and place it somewhere while keeping it
insulated, as it carries voltage from the system.
Publicidad
