Haier GWT560BW Manual Del Usuario página 16

ESTIMATED TIME REMAINING DISPLAY
r
This display shows the estimated total time for a wash cycle in minutes.
As the washer operates, the minutes will count down to show the time
remaining. The original estimated time may be recalculated as the washer
adjusts for load size and other variables.
r
When using the Delay Wash feature, this display will show the number of
hours selected for a delay start of the washer.
r
If the washer senses a malfunction, an error code will be shown in the
display. Please refer to the "Troubleshooting" section for a list of error codes
and their possible causes and solutions.
FABRIC SOFTENER BUTTON
r
Turn this feature on when using the fabric softener dispenser. This will
ensure that the selected wash cycle is optimized for a rinse additive. At the
VWDUW RI WKH QDO ULQVH IDEULF VRIWHQHU ZLOO EH UHOHDVHG LQWR WKH ZDVK ORDG DV
WKH GLVSHQVHU LV XVKHG ZLWK ZDWHU
DELAY WASH BUTTON
r
Use this button to select a delayed start of the washer. The number of hours
will be shown in the Estimated Time Remaining Display. Each press of the
Delay Wash Button will increase the time by 1 hour.
r
One button press after 24 will cancel the delay wash feature. You can also
FDQFHO WKH 'HOD\ :DVK IHDWXUH E\ WXUQLQJ R SRZHU WR WKH ZDVKHU ZLWK WKH
Power Button.
r
The LED above the button indicates that the Delay Wash feature has been
selected. The Start/Pause Button must be selected to begin the countdown.
The LED indicator will blink signaling that the delay function is operating.
NOTE: The washer lid must be closed to begin the delay countdown. Opening
the lid will pause an active countdown. To resume the countdown, close the lid
and press the Start/Pause Button.
CYCLE SIGNAL BUTTON
r
Use this button to adjust the volume of control panel beeps and the end-of-
F\FOH VLJQDO $IWHU WKH ZDVKHU LV SRZHUHG R  WKH VLJQDO UHWXUQV WR WKH +LJK
setting.
EXTRA RINSE BUTTON
r
Use this button to select or deselect the Extra Rinse option.
NOTE: The Whites cycle automatically selects the Extra Rinse option.
PRE-SOAK OPTION
r
Press and hold the Extra Rinse Button for 3 seconds to select and deselect
this option. The Soak indicator in the Cycle Status group will light when Pre-
soak is selected.
NOTE: The Whites, Heavy Duty, and Eco Wash cycles automatically select
the Pre-Soak option.
14