Uline H-7620 Manual Del Usuario página 2

CLAMP MOUNTING
1
Clamp
Mounting
Bracket
5
Tighten
NOTE: Clamp mount is compatible with desk
thickness of 3/4 – 4¾".
1. Attach clamp mounting bracket (2) to bottom of
monitor arm base using M6 x 12 mm bolts (C) and
4 x 4 Allen wrench (G). (See Figure 2)
2. Apply anti-slip foam for base (5) to bottom of monitor
arm base.
3. Apply anti-slip foam for clamp (4) over ring on clamp (3).
GROMMET MOUNTING
1 2
Grommet
Bolt
Grommet
Mounting Plate
NOTE: For grommet mounting, hole in desk
must be 3/8 – 2¾".
NOTE: Grommet mount is compatible with desk
thickness of 1 – 3⁄".
1. Insert grommet bolt (6) through center of grommet
mounting plate (7); counterbore side down.
(See Figure 3)
2. Attach grommet mounting plate (7) to bottom of
monitor arm base using M6 x 12 mm bolts (C) and
4 x 4 Allen wrench (G).
PAGE 2 OF 12
2
M6 x 12 mm
Bolts
4 x 4
Allen
Wrench
Arm Base
Desk
3
Anti-Slip
Foam for
Base
M6 x 12 mm
Bolts
ASSEMBLY
Anti-Slip
Foam for
Base
Monitor
4. Attach clamp (3) to the clamp mounting bracket (2)
using M6 x 10 mm bolts (D) and 4 x 4 Allen wrench (G).
5. Place clamp mounting bracket and clamp over
desk and fully tighten knob.
4
3. Apply anti-slip foam for base (5) to bottom of monitor
arm base.
4. Insert grommet bolt (6) into hole of desk.
5. Apply anti-slip foam for bottom supports (8) to
bottom support (9).
6. Thread grommet bolt (6) through bottom support (9)
and attach knob (10) to end of bolt. Fully tighten
knob.
3
M6 x 10 mm
Bolts
Anti-Slip
Foam for
Clamp
Ring
Clamp
Mounting
Holes
NOTE: Select the appropriate mounting holes
based on the thickness of the desk.
5
Anti-Slip Foam for
Bottom Support
Hole
Bottom
Support
4
Clamp
Mounting
Bracket
Figure 2
6
Knob
Figure 3
Tighten
0521 IH-7620