Uline H-7620 Manual Del Usuario página 3

ATTACHING MONITOR
1
Bolt
Washer
NOTE: Two-person assembly is required for this
step.
NOTE: Depending on size of holes, use either
M4 x 12 mm bolts (A) or M5 x 12 mm bolts (B). If
holes are not deep enough, add flat washers (F)
to bolts to ensure a tight fit.
1. One person should hold the monitor and align
the bolt holes on the back of the monitor with the
mounting plate. The second person should insert
bolts into the top two holes in the mounting plate and
monitor. Loosely tighten both bolts. (See Figure 4)
ADJUSTING MONITOR
NOTE: Easy-adjust monitor includes a built-in
counterweight system for free range of motion.
Arm or mount may need to be adjusted to
allow monitor to stop at desired position.
1. To adjust the counterweight, use 5 x 5 Allen wrench (H)
on bolt above middle joint. Turn towards "–" if
monitor raises when released. Turn towards "+" if the
monitor lowers when released. Adjust until mount
can be stopped at desired position. (See Figure 5)
2. To adjust the tilt function, use 5 x 5 Allen wrench (H)
and 4 x 4 Allen wrench (G) on bolts near mounting
plate. (See Figure 5)
PAGE 3 OF 12
ASSEMBLY CONTINUED
2
2. While one person continues to hold the monitor, the
second person should insert bolts into the bottom
two holes in the mounting plate and monitor. Then,
fully tighten all four bolts.
Figure 5
NOTE: For 100 x 100 mm VESA hole pattern,
bolts can be inserted into the top holes in back
of monitor and lowered into mounting plate for
easier attachment.
H
±90º
±180º
Figure 4
G
~90º ~15º
1
H
±135º
±180º
0521 IH-7620