RU252ok.qxd:RU252.qxd
All manuals and user guides at all-guides.com
Setting the remote control
This is only necessary if your appliance does not respond to the RU252.
If that is the case, the RU252 does not recognize the brand and/or model of
your appliance and you need to program the remote control to do so.
The example below (TV) instructs you how to do this. You can repeat the
same steps for other appliances (VCR/DVD players/recorders) which you
want to operate using the RU252.
Example of TV:
1
Turn on the TV manually or use the original remote control.
Tune in to channel 1.
2
Look up the brand of your TV in the code list at the back of this manual.
One or more four-figure codes are shown for each brand.
Note the first code.
Be careful! There are separate tables for TV, VCR and DVD.
Make sure you use the codes from the correct table.
3
Keep the TV Key pressed for 3 seconds until
the green indicator light remains lit.
4
Then enter the code noted in step 2 using
the digital keys.
–
The green indicator light will now flash twice.
If the light flashes once for an extended period,
the code has not been entered properly or
the wrong code has been entered. Start again
from step 2.
5
Point the RU252 at the TV and check that it responds as it should.
–
If the TV responds to all of the key commands, the RU252 is ready for
use. Do not forget to note your code.
•
If the device does not respond at all, or not to all of the
key commands, start again from step 2 and try the next code
from the list.
17/08/07
15:56
Page 5
Instructions for use
5