Setting The Remote Control - Philips SRU 152 Instrucciones De Utilizacion

SRU152.qxd 13-01-2005 12:30 Pagina 5
All manuals and user guides at all-guides.com

Setting the remote control

This is only necessary if your TV does not respond to the SRU152.
If that is the case, the SRU152 does not recognize the brand and/or model of
your TV and you need to program the remote control to do so.
The example below instructs you how to do this.
1
Turn on the TV manually or use the original remote control.
Tune in to channel 1.
2
Look up the brand of your TV in the code list at the back of this
manual. One or more five-figure codes are shown for each brand.
Note the first code.
3
Keep keys s and y on the SRU152 pressed
simultaneously for five seconds until the
green LED remains lit.
4
Then enter the code noted in step 2
using the remote control keys as follows:
- PROG + for entering 1;
- VOL – for entering 2;
- VOL + for entering 3;
- PROG – for entering 4;
- Mute (s) + for entering 5.
– The green LED will now flash twice.
If the LED flashes once for an extended period, the code has not been
entered properly or the wrong code has been entered.
Start again from step 2.
5
Point the SRU152 at the TV and check that it responds as it should.
– If the TV responds to all of the key commands, the SRU152 is ready for
use. Do not forget to note your code.
• If the device does not respond at all, or not to all of the
key commands, start again from step 2 and try the next code
from the list.
Instructions for use
5