Bosch T1B Instrucciones De Funcionamiento Y Seguridad página 9

2610001768_T1B 8/17/17 8:57 AM Page 9
MOUNTING THE MITER SAW TO THE STAND
See Figures 8 - 9.
1. Lift the saw and bracket assembly, allowing the
assembly to tilt slightly toward your body.
2. While still tilted toward you, hook the front edge of
the bracket assembly onto the front rail (1) of the
stand, figure 8.
front edge of the mounting brackets are securely
seated over the front rail before seating the other
end of the brackets. Failure to do so could cause
you to lose control of the saw mounting assembly.
3. Lower the bracket assembly to allow the rear edge
of the bracket to seat fully over the rear rail (2),
figure 8.
4. Lock the brackets in position by tightening the
locking knobs (3).
NOTE: Continue to hold the mounting bracket
assembly with one hand until both levers are securely
locked.
5. Check position and adjust, if necessary, to make
sure the weight of the saw is evenly balanced over
the rails as shown in figure 9.
6. Ensure the saw is fully seated and locked in
position, then securely tighten the four nuts holding
the saw to the saw mounting brackets.
To remove saw from stand:
1. Loosen the locking knobs to unlock the saw and
mounting bracket assembly.
2. Lift the saw away from the rear rail of the stand to
disengage.
3. With the assembly tilted slightly toward you, lift the
front part of the assembly to disengage from the
front rail of the stand.
assembly from the rails. If the mounting brackets will not fit over the rails, or if the mounting brackets can be
removed from the rails when the brackets are locked, remove from the saw and bracket assembly immediately
and tighten the bracket adjustment screw as described in the Adjustments section of this manual. Failure to heed
this warning may result in personal injury.
Assembly
To avoid serious personal
injury, make sure the curved
The mounting brackets are designed to fit snugly over the stand rails. With the locking knobs
in the tightened (locked) position, you should not be able to remove the saw and bracket
FIG. 8
2
FIG. 9
9
1
3
3