Bartscher MX 235 Manual De Instrucciones Originales página 34

The device assembly consists of a few operations:
1. Place the retaining flange (5)
of the mixing stick shank (6)
on the quick-coupling (2) of
the device body (3).
2. Rotate the mixing stick shank
(6) anticlockwise, so it is
connected with the device
body (3) in a rigid way.
Follow the instructions on
the device body!
The disassembly is performed as above, but in opposite order.
Start
The impulse start is performed only by pressing the appropriate ON/OFF button:
operation only with pressed button
No power
In case of power supply failure or after disconnecting the device from the supply it may
be restarted after following the procedure of start-up after the power restoration or
connecting the device to the supply installation.
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid
specification should be compared with that of the device
(see type label).
Connect the device only in case of compliance!
- 30 -
③
②
⑥
①
⑤