Specifications - Mitsubishi Electric Mr.SLIM PEAD-M35JA2 Manual De Instrucciones

6. Trouble Shooting
Having trouble?
Noise is louder than specifications.
Nothing appears in the wireless remote controller display, the display
is faint, or signals are not received by the indoor unit unless the remote
controller is close.
After battery installation/replacement of remote controller, part of function
cannot be used.
The operation lamp near the receiver for the wireless remote controller
on the indoor unit is flashing.
The wireless remote controller does not operate (the indoor unit beeps
4 times).
The indoor unit which is not operating becomes warm and a sound,
similar to water flowing, is heard from the unit.

7. Specifications

Item
Power source
Dimension Height / Width / Depth
Net weight *( ): JAL, JAL2 type
Airflow rate (Low-Middle-High) m
Fan
External static pressure
Sound pressure level (Low-Mid-High)
Item
Power source
Dimension Height / Width / Depth
Net weight *( ): JAL, JAL2 type
Airflow rate (Low-Middle-High) m
Fan
External static pressure
Sound pressure level (Low-Mid-High)
■ The indoor operation sound level is affected by the acoustics of the
■ The batteries are low.
■ If nothing appears even after the batteries are replaced, make sure that
■ Please check that the clock setting is completed. If clock setting is not
■ The self diagnosis function has operated to protect the air conditioner.
■ Do not attempt to repair this equipment by yourself.
■ Switch the auto mode setting to the AUTO (single set point) mode or
■ A small amount of refrigerant continues to flow into the indoor unit even
Model PEAD-(S)M35JA(L)(2)
mm 250/900/732
kg 25.0 (24.5)
3 /min 10.0-12.0-14.0
Pa
35/50/70/100/150
dB(A) 24-29-32
Model PEAD-(S)M100JA(L)(2)
mm 250/1400/732
kg 37 (36)
3
/min 23.0-28.0-32.0
Pa
dB(A) 31-36-39
Here is the solution. (Unit is operating normally.)
particular room as shown in the following table and will be higher than
the noise specification, which was measured in an echo-free room.
High sound-
absorbing
rooms
Broadcasting
Location
studio, music
examples
room, etc.
Noise levels 3 to 7 dB
Replace the batteries and press the Reset button.
the batteries are installed in the correct directions (+, –).
done, please complete.
Turn off the power switch immediately and consult your dealer. Be sure
to provide the dealer with the model name.
AUTO (dual set point) mode. For details, refer to the included Notice (A5
sheet) or the Installation Manual.
though it is not operating.
PEAD-(S)M50JA(L)(2) PEAD-(S)M60JA(L)(2)
220-240V 50Hz
250/900/732 250/1100/732
26.5 (25.5) 29.5 (29.0)
12.0-14.5-17.0 14.5-18.0-21.0
27-33-35 26-32-35
PEAD-(S)M125JA(L)(2) PEAD-(S)M140JA(L)(2)
220-240V 50Hz
250/1400/732 250/1600/732
38 (37)
28.0-34.0-37.0 29.5-35.5-40.0
40/50/70/100/150
35-39-41 34-38-41
Low sound-
absorbing
Normal rooms
rooms
Reception
Office, hotel
room, hotel
room
lobby, etc.
6 to 10 dB 9 to 13 dB
PEAD-(S)M71JA(L)(2)
250/1100/732
29.5 (29.0)
14.5-18.0-23.0
40/50/70/100/150
26-32-37
42 (41)
11