Operation; Turning On/Off; Mode Select - Mitsubishi Electric Mr.SLIM PEAD-M35JA2 Manual De Instrucciones

3. Operation

■ About the operation method, refer to the operation manual that comes with each remote controller.

3.1. Turning ON/OFF

3.1.1. For wired remote controller
[ON]
Press the [ON/OFF] button.
The ON/OFF lamp will light up in green,
and the operation will start.
When "LED lighting" is set to "No," the ON/
OFF lamp will not light up.
* Refer to the installation manual of wired
remote controller.
Note:
Even if you press the ON/OFF button immediately after shutting down the operation is progress, the air conditioner will not start for about three minutes.
This is to prevent the internal components from being damaged.
■ Operation status memory
Operation mode Operation mode before the power was turned off
Preset temperature Preset temperature before the power was turned off
Fan speed Fan speed before the power was turned off

3.2. Mode select

3.2.1. For wired remote controller
Each pressing of the [F1] button cycles
through the following operation modes.
Select the desired operation mode.
• Operation modes that are not available to
the connected indoor unit models will not
appear on the display.
What the blinking mode icon means
The mode icon will blink when other indoor units in the same refrigerant
system (connected to the same outdoor unit) are already operated in a
different mode. In this case, the rest of the unit in the same group can
only be operated in the same mode.
6
Remote controller setting
Cool Dry Fan
Auto Heat
[OFF]
Press the [ON/OFF] button again.
The ON/OFF lamp will come off, and
the operation will stop.
■ Settable preset temperature range
Operation mode Preset temperature range
Cool/Dry 19 – 30 °C
Heat 17 – 28 °C
Auto 19 – 28 °C
Fan/Ventilation Not settable