IRUDEK TRIP4 Manual De Instrucciones página 17

through the Harmonized European Standard EN 795:2012 B.
The declaration of conformity is available at the following internet address:
http://www.irudek.com/es-es/descargas/
DESCRIPTION
The tripod is a portable anchorage point for connection to a fall arrest system ( EN 363 ).
APPLICATION
The tripod is designed to protect the people that work on confined spaces and can also be used for
rescue, evacuation, confined space entry/exit operations, material lifting and lowering...
CHARACTERISTICS
Working height : adjustable 2,22-3,14 cm
Weight : 23,6 kg
Non-slip feet base
Leg base chain
Tripod head made of aluminium alloy
Working load : 500 kg
Internal base distance : 1,7-2,45 m
HEAD
Has 2 pulleys and 2 anchorage rings for connection to fall arrest systems ( EN 363 ).
ADJUSTABLE LEGS
The telescopic construction of the legs allow to adjust the height of the tripod in 9 different heights.
The legs are adjusted by inserting the pin through the selected holes.
CHAIN
The leg chain is necessary to maintain the position of the tripod legs and to distribute the applied
loads during the system use.
PLEASE NOTE : The chain can cause a stumble to a person near the tripod.
BAG
The bag is made of nylon and designed to protect the tripod during transport and storage.
ERECTING A ND ADJUSTING THE TRIPOD
CAUTION : Do not open the confined space access cover before completing installation of the
tripod and all other system components.
-Put the tripod into an upright, feet-down position.
-Position the feet about the hatch cover in accordance with working area and surface.
-Raise the tripod. Pull the pin on the leg to adjust to the desired height and insert the pin again.
Repeat the procedure for each leg, one by one.
-Check that the system is stable and the tripod head is level.
-Pass the leg chain from the bottom of the legs and adjust.
-Check that the pins of the legs are fixed in a safe way and install the bases in a completely
extended position.
-Check the vertical position and stability.
-The pulley is used to pass the winch's wire rope cable through for the lifting and lowering of
people or materials.
-The anchorage point is used for connection to a fall arrest system in conformity to EN 363.