How To Use - Metabo HPT FDV 16VB2 Manual De Instrucciones

HOW TO USE

CAUTION:
To prevent accidents, make sure to turn the switch off and disconnect the plug from
the receptacle when the drill bits and other various parts are installed or removed.
The power switch should also be turned off during a work break and after work.
1. Switch operation
○ When the trigger switch is depressed, the
tool rotates. When the trigger is released,
the tool stops.
○ The rotational speed of the drill can be
controlled by varying the amount that the
Trigger switch is pulled. Speed is low when
the trigger switch is pulled slightly and
increases as the trigger switch is pulled
more.
○ The desired rotation speed can be pre-
selected with the speed control dial.
Turn the speed control dial clockwise for
higher speed and counterclockwise for
lower speed. (Fig. 7)
○ Pulling the trigger and pushing the stopper,
it keeps the switched-on condition which
is convenient for continuous running.
When switching off , the stopper can be
disconnected by pulling the trigger again.
2. When using as a Drill or a Hammer Drill
(1) Pressing force of the drill
You cannot drill holes more quickly even if you press the drill with a stronger force than
necessary. It not only damages tip of drill bits and decreases the effi ciency of operation, but
also shortens the life of the drill.
(2) In case of penetrating holes
Drill bits can be broken when the material being drilled is penetrated. It is important to
decrease pressing force just before penetrating.
CAUTION: In continuous operation, conduct no-load operation for fi ve seconds
after completing a drilling job.
WARNING:
When a thick drill bit is used, your arm is subjected to larger
reaction force. Be careful not to be moved by the reaction force.
For this, establish a foothold, hold the unit tightly with both hands
perpendicularly to the material being drilled.
Speed
control dial
Low speed
Fig. 7
English
Stopper
High
speed
11