Uline H-1488 Manual Del Usuario página 4

FOR BINS 9" HIGH
(S-14454)
Attach crossbars (C) to the fifth and sixth holes up from
the bottom using #14 sheet metal screws (E). Skip three
holes, attach the remaining crossbars after every third
hole. (See Figure 8)
NOTE: Attach each base assembly (A) to the
third hole up using #14 sheet metal screws (E).
(See Figure 8)
FOR BINS 10" HIGH
(S-12421)
Attach a crossbar (C) to the fifth hole up from the bottom
using #14 sheet metal screws (E). Skip one hole and
place crossbar in seventh hole from bottom. Skip three
holes, attach the remaining crossbars after every third
hole. (See Figure 9)
NOTE: Attach each base assembly (A) to the
third hole up using #14 sheet metal screws (E).
(See Figure 9)
FOR BINS 11" HIGH
(S-12422)
Attach crossbars (C) to the sixth and seventh holes up
from the bottom using #14 sheet metal screws (E). Skip
three holes, attach the remaining 11 crossbars after
every third hole. (See Figure 10)
NOTE: Attach each base assembly (A) to the
third hole up using #14 sheet metal screws (E).
(See Figure 10)
PAGE 4 OF 15
RACK ASSEMBLIES FOR SPECIFIC ULINE BINS
E
A
Figure 8
E
A
Figure 9
E
A
Figure 10
C
C
C
0521 IH-1488