Setting The Cutting Height - Cub Cadet Commercial 53AWEFJA603 Instrucciones De Funcionamiento Originales

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 112
EN
Driving
WARNING !
Risk posed by abrupt starting, sudden
stopping and driving at an excessively high
speed.
Risk of accidents
Drive slowly and brake slowly.
Do not drive at excessive speed.
Be particularly careful when reversing.
Never change the direction of travel with-
When entering corners, always reduce
your speed and adjust the speed to the
turning radius (the tighter the corner, the
lower the speed).
Never adjust the steering column or the
driver's seat when in motion.
Never operate the device without the
rollbar or cutter deck.
Do not operate the device with the rollbar
folded down.
Always wear a seat belt when the rollbar
is folded up.
Do not fasten the seat belt when the
rollbar is folded down.
Attention !
Do not step on the forward or reverse pedal
while you are activating the brake pedal or the
parking brake is activated. This may damage the
gears.
Brake pedal
A
Forward pedal
B
Reverse pedal
C
Switch for parking brake/Speed control
D
Sit down on the driver's seat.
Put on the seat belt.
Start the engine.
Release the parking brake by pushing right
through the brake pedal and then releasing it
again.
To drive off, press on the accelerator [B] or [C]
Note
The further you step on the accelerator
pedal, the quicker the machine will go.
18
Driving with speed control
When driving, press the switch [D]
The forward speed selected at this point (but not
top speed) is maintained.
You can take your foot off the accelerator pedal.
To switch the speed control off, press the brake
pedal [A]/accelerator pedal [B] until the switch is
released.
Stopping the device
Take your foot off the accelerator [B] or. [C].
Step on the brake pedal [A] until the device
comes to a stop.
Note
When you step on the brake pedal, you
automatically switch the speed control off at
the same time.
Switching the cutter deck on/off
(depending on the model)
The PTO switch actuates an mechanical clutch to
switch ON and OFF the cutters.
To switch the cutter deck on, pull the PTO
switch
.
To switch the cutter deck off, press the PTO
switch
.

Setting the cutting height

To set the cutting height, press the cutting height
adjustment lever [3].
Transport position:
The lever is in the top position "T". The lever is
locked in this position.
Cutter deck removal/installation position:
The locking pin [2] is in the position "
The cutting height adjustment lever is above it
latched in on the locking pin.
Mowing position:
The locking pin [2] is in the holes with the mark-
ings "1" to "4, 5". The cutting height adjustment
lever is above it latched in on the locking pin.
Note
After insertion, the locking pin must be
turned downwards so that it cannot come
loose from the pegging hole of its own ac-
cord. In the positions "Mowing position" and
"Removal/installation", the locking pin must
always be located underneath the cutting
height adjustment lever, and the lever must
be correctly latched in on the locking pin.
Operation
.
".
769-11757

Publicidad

Tabla de contenido
loading

Tabla de contenido