Tips On Lawn Care - Cub Cadet Commercial 53AWEFJA603 Instrucciones De Funcionamiento Originales

Operation
Note
The "transport position" and Removal/instal-
lation position" must not be used for mow-
ing, because the cutter deck's V-belt can
become damaged as a result.
Press the knob [1] on the cutting height adjust-
ment lever and pull the lever right up
locks into the transport position "T".
Select the cutting height by inserting the locking
pin [2] in a hole of the locking plate
Note
Each hole shifts the cutter deck by approx.
6.4 mm. The lowest cutting height is around
3 cm; and the largest around 11 cm.
Press the knob [1] on the cutting height adjust-
ment lever and lower the lever downwards into the
required position .
Release the knob .
The cutting height adjustment lever latches in on
the locking pin.
Mowing
CAUTION !
Risk of injury
Only empty the grass catcher when the
cutters are switched off.
Only operate the device with the
Attention !
If the cutters come into contact with a foreign
body (e.g. a stone), or if the device starts
to vibrate unusually, switch the engine off
immediately.
Check the device for damage before continuing
operation. In the event of damage, discontinue
use of the device and have it repaired by
a service centre prior to putting back into
operation.
Do not activate the cutter deck in high grass.
Note
The device permits reversing with the cut-
ters switched on (reverse mowing mode).
Exercise particular caution when reversing
with the cutters switched on. Only reverse
with the cutter deck switched on if absolutely
necessary.
769-11757
so the cut grass is thrown out sideways into the
middle.
Do not allow the grass to grow too long, and never
cut it too short.
Drive in straight lines an do not mow at high speed,
particularly when a mulching kit or grass catcher is
until it installed.
Sit down on the driver's seat.
. Put on the seat belt.
Start the engine as indicated.
Set the throttle to
Switch the cutter deck on and then lower it.
Release the parking brake by pushing right
through the brake pedal and then releasing it
again.
To drive off, press on the accelerator pedal.
Information on mowing
Do not mow wet grass. Drive slowly at
maximum engine speed. When adjusting the
cutting height and travel speed, ensure that
the device is not overloaded. Depending on
the length, type, and dampness of the grass,
adjust the cutting height and driving speed in
order to be able to collect grass with a grass
catcher without any trouble.
Information on mowing
In the event of blockages, reduce speed and
raise the cutting height.

Tips on lawn care

Mowing
A lawn is made up of various different types of
grass. If you mow your lawn frequently, those types
surface will grow better. If you seldom cut the grass,
you will enhance the development of high-growing
types of grass and other weeds, such as clover,
daisies ...).
The normal height of a lawn is approx. 4–5 cm. Only
1/3 of the total height should be mown; therefore
cut 7–8 cm long grass to normal height. Preferably
do not cut the lawn shorter than 4 cm, otherwise
the turf will be damaged in a dry period. If the grass
has grown particularly high (for example, during a
holiday period), cut it back to its normal height in
stages.
.
EN
19