Setting The Cutting Height - Cub Cadet Commercial 53RWEHRF603 Instrucciones De Funcionamiento Originales

EN
Switching the cutter deck on/off
(depending on the model)
The PTO switch actuates an mechanical clutch to
switch ON and OFF the cutters.
To switch the cutter deck on, pull the
PTO switch .
To switch the cutter deck off, press the
PTO switch .

Setting the cutting height

To set the cutting height, press the cutting height
adjustment lever [3].
Transport position:
The lever is in the top position "T". The lever is
locked in this position.
Cutter deck removal/installation position:
The locking pin [2] is in the position "
This secures the cutting height adjustment lever
located under the locking pin.
Mowing position:
The locking pin [2] is in the holes with the mark-
ings "1" to "4, 5". The cutting height adjustment
lever is above it latched in on the locking pin.
Note
After insertion, the locking pin must be
turned downwards so that it cannot come
loose from the pegging hole of its own ac-
cord. In "Mowing position", the locking pin
must always be located underneath the
cutting height adjustment lever, and the lever
must be correctly latched in on the locking
pin.
Note
The "transport position" and Removal/instal-
lation position" must not be used for mow-
ing, because the cutter deck's V-belt can
become damaged as a result.
Press the knob [1] on the cutting height adjust-
ment lever and pull the lever right up
locks into the transport position "T".
Select the cutting height by inserting the locking
pin [2] in a hole of the locking plate
Note
Each hole shifts the cutter deck by approx.
6.4 mm. The lowest cutting height is around
3 cm; and the largest around 11 cm.
20
Press the knob [1] on the cutting height adjust-
ment lever and lower the lever downwards into the
required position
Release the knob
The cutting height adjustment lever latches in on
the locking pin.
Mowing
If a foreign object (like a stone) comes into
contact with the cutting mechanism, or if the
".
device starts to vibrate unusually, switch the
engine off immediately.
Inspect the device for damage before continuing
operation. In the event of damage, discontinue
use of the device and have it repaired by
a service centre prior to putting back into
operation.
Do not activate the cutter deck in high grass.
Note
The device permits reversing with the cut-
ters switched on (reverse mowing mode).
Exercise particular caution when reversing
with the cutters switched on. Only reverse
with the cutter deck switched on if absolutely
necessary.
so the cut grass is thrown out sideways into the
middle.
Do not allow the grass to grow too long, and never
cut it too short.
Drive in straight lines an do not mow at high speed,
particularly when a mulching kit or grass catcher is
until it installed.
Sit down on the driver's seat.
. Put on the seat belt.
Start the engine as indicated.
Set the throttle to
Switch the cutter deck on and then lower it.
Release the parking brake by pulling both control
levers into the neutral position.
To drive away, press both control levers forwards
slowly and evenly. The further they are pressed
forwards, the faster the device moves.
.
.
CAUTION!
Risk of injury
Only empty the grass catcher when the
cutters are switched off.
Only operate the device with the
Attention!
.
Operation
769-12264