Tips On Lawn Care; Switching The Device Off; Display Cluster (Depending On The Model; Optional) - Cub Cadet Commercial 53RWEHRF603 Instrucciones De Funcionamiento Originales

Display cluster (depending on the model; optional)

Information on mowing
Do not mow wet grass. Drive slowly at
maximum engine speed. When adjusting the
cutting height and travel speed, ensure that
the device is not overloaded. Depending on
the length, type, and dampness of the grass,
adjust the cutting height and driving speed in
order to be able to collect grass with a grass
catcher without any trouble.
Information on mowing
In the event of blockages, reduce speed and
raise the cutting height.

Tips on lawn care

Mowing
A lawn is made up of various different types of
grass. If you mow more frequently, the grown of
turf. If you seldom cut the grass, you will enhance
the development of high-growing types of grass and
other weeds (e.g. clover, daisies ...).
The normal height of a lawn is approx. 4–5 cm. Only
1/3 of the total height should be mown; therefore
cut 7–8 cm long grass to normal height. Preferably
do not cut the lawn shorter than 4 cm, otherwise the
turf will be damaged in a dry period. If the grass has
grown particularly high (e.g. during a holiday period),
cut it back to its normal height in stages.
Mulching using the accessories (optional)
With mulching, the grass is cut into small pieces
(approx. 1 cm) during mowing and is left on the
ground. A lot of the nutrients in the cut grass are
Ask your specialist dealer for appropriate mulching
accessories.
Note
This device is designed to mow lawns. Do
not mow scrub, weeds, or overlong grass.
Pay attention to the following notes:
Do not mow any wet grass, and never more
than max. 2 cm.
Mow the entire length of grass.
Drive slowly and at maximum engine speed.
Clean the lawn mower deck regularly.

Switching the device off

Stop the device.
Switch the cutter deck off.
Set the throttle to the middle position.
Bring the cutter deck to the top position.
Switch the engine off after 20 seconds.
Switch the parking brake on.
Shut the fuel tap.
Remove the ignition key.
769-12264
Pushing the device
Switch the engine off.
Switch the parking brake off.
Pull both gear release levers (near the left and
right rear wheel) back and press them downwards
into the recess.
You can now push the device.
Note
Never tow the device. This can cause seri-
ous damage to the gears.
To continue driving, pull both gear release levers
out from the recess and push them forwards.
Display cluster
(depending on the model; optional)
Note
The indicators only come on when the en-
gine is running.
Note
occur at the same time, the oil change
indicator.
Depending on the model, the display cluster can
consist of the following elements
1 Oil pressure If this indicator light is illuminated
when the engine is running,
switch the engine off immediately
and check the oil level. If nec-
essary, pay a visit to a service
centre.
2 Brake This indicator lamp lights up if the
brake pedal is not depressed or
the parking brake is not locked
when the engine starts.
3 Cutter deck This indicator lamp lights up
(PTO) when the cutters are not switched
OFF at engine start (PTO).
4 Battery charge This indicator light lights up with
indicator the engine running if the bat-
necessary, pay a visit to a service
centre.
EN
:
21