Maintenance - Kunft KVH3935 Manual De Instrucciones

Placa vitrocerámica
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. If the cable is damaged or needs replacing, this should be done
by a customer service technician using the proper tools, to avoid
any accidents.
2. If the appliance is being connected directly to the mains supply, an
omnipolar circuit breaker must be installed with a minimum gap of
3 mm between the contacts.
3. The installer must ensure that the correct electric connection has
been made and that it complies with safety regulations.
4. The cable must not be bent or compressed.
5. The cable must be checked regularly and only replaced by a
properly qualified person.

2.3. Maintenance

What?
everyday
soiling of
the glass
(fingerprints,
marks, food
stains or
non-sugary
spillovers on
the glass)
boil-over,
melts, and
hot sugary
spills on the
glass
Placa-Vitro-KVH1966-Manual-4.indd 17
ceramic hob
How?
1. Switch the hob power off.
2. apply a hob cleaner while
the glass is still warm
(but not hot!)
3. rinse and wipe dry with
a clean cloth or paper
towel.
4. Switch the hob power
back on.
remove these immediately
with a fish slice, palette
knife or razor blade scraper
suitable for ceramic glass
hobs, but beware of hot
cooking zone surfaces:
1. Switch the hob power off
at the wall.
2. Hold the blade or utensil
at a 30° angle and scrape
the dirt or spill to a cool
area of the hob.
3. clean the dirt or spill with
a dishcloth or paper towel.
4. follow steps 2 to 4 for
'everyday soiling of the
glass' above.
KVH3935
Important!
• When the power to
the hob is switched
off, there will be no
'hot surface' indication
but the cooking zone
may still be hot! Take
extreme care.
• Heavy-duty scourers,
some nylon scourers
and harsh/abrasive
cleaning agents may
scratch the glass.
always read the label
to check if your cleaner
or scourer is suitable.
• Never leave cleaning
residue on the hob:
the glass may become
stained.
• Remove stains left by
melts and sugary food
or spillovers as soon
as possible. If left to
cool on the glass,
they may be difficult
to remove or even
permanently damage
the glass surface.
• Cut hazard: when
the safety cover is
retracted, the blade
in a scraper is razor-
sharp. use with
extreme care and
always store safely
and out of reach of
children.
17
EN
16/04/12 19:27

Publicidad

Tabla de contenido
loading

Tabla de contenido