Gate Assembly - Evenflo Walk-Thru 4461000 Manual Del Usuario

DO NOT remove cardboard cover (or plastic tie
beneath it) at this time, or serious injury may result.
A
D
A
WARNING
1. Measure and record the width of the
opening where you will use the gate.
If the opening is wider than 33.75 in.
(85.73 cm), refer to page 2 for Proper
Set-Up Configurations.
NOTE: If frame extension is not
required, go to Step 3.
2. If frame extension is required, insert
small extension pins
and lower openings in the gate frame
, as shown. Push the appropriate
A
frame extension
pins
on the gate frame
extension
plastic caps MUST touch each other
B
to securely install the frame extension.
NOTE: Frame extension can be
installed on either side of gate.
A D
D
onto the extension
B
. Make sure the plastic caps
D
A
touch each other. The
B
B

Gate Assembly

into the upper
and the gate
3