Mounting Cap Installation - Evenflo Walk-Thru 4461000 Manual Del Usuario

WARNING
Mounting caps MUST be installed
to use gate at top of stairs.
F
E
E
H
NOTE: If not installing gate at top of
stairs, go to step 8.
5. Peel backing off one side of adhesive
pad
mounting cap
Peel backing off other side of adhesive
pad, and place mounting cap over end
of adjustment bumper
NOTE: Make sure gate stays straight up
D
and down (90º to floor) and in center of
door frame during this process.
Slide adjustment bumper
gate frame toward door frame, until
mounting cap sticks to door frame.
Repeat this for other three mounting
caps.
6. Once all four mounting caps are in
D
place remove gate from opening in
order to secure mounting caps to
door frame with supplied screws
Tighten all four screws securely with
handheld Phillips screwdriver, but do
not overtighten.
NOTE: If mounting to drywall, mark
center of mounting caps. Pull mounting
caps off wall. Drill holes and insert wall
anchors
screws. Tighten all four screws securely
with handheld Phillips screwdriver, but
G
do not overtighten.
7. Position gate
mounting caps.

Mounting Cap Installation

. Adhere pad to outside of
F
, as shown.
E
. Secure mounting caps with
G
on floor in line with
A
.
D
out of
D
.
H
5