Waeco CoolAir CA-800-Mercedes-2 Instrucciones De Instalación página 26

CA-800-Install.book Seite 26 Mittwoch, 20. Februar 2008 12:28 12
Installation
You should always check whether any vehicle components could be
damaged or their function impaired by installing the roof air conditioner
before doing so. Using you can check the dimensions of the installed
system. The broken line here shows the middle of the roof hatch.
Before installation, find out (by consulting the manufacturer of the
vehicle) whether the construction is designed for the static weight and
the loads of the air conditioner when the vehicle is in motion. The
manufacturer of the roof air conditioner assumes no liability whatsoever.
The roof inclination of the mounting surface may not be more than 8° to
the front and 0° to the rear.
The supplied assembly parts may not be modified by the customer
when installing them.
Note the connection plan for the roof air conditioner:
No. in Fig. 8
on page 6
Improper installation of the roof air conditioner can result in irreparable da-
mage to the device and put the safety of the user at risk.
If the roof air conditioner is not installed according to the manufacturer's in-
structions, the manufacturer does not assume any liability. The
manufacturer assumes no liability for malfunctions or for the safety of the
roof air conditioner, especially for personal injury and/or damage to pro-
perty.
After installing the system, the specified parameters of the system soft-
ware must be checked (see chapter "Configuration of system software" on
page 30).
26
All manuals and user guides at all-guides.com
Description
1 Control pad
2 12 + 2 pin ribbon cable
3 Room temperature sensor
4 Level sensor
5 Earth
6 Klickson (compressor)
7 Compressor
8 Water pump
9 Secondary fan
10 Main fan
11 Earth
12 Remote control receiver
13 125 mA fuse
CoolAir