Product View - Sinbo SSI 2893G Manual De Instrucciones

Notices
Plug the power plug in thoroughly to avoid
electric shock, as well as open circuit,
short circuit, smoking and flammation
caused by over-heat of plug.
No watering: danger of short circuit and
electric shock.
Do not use broken or loose socket in
respect of electric shock, short circuit and
flammation.
Do not intend to refit, remove or repair the
product in respect of fire, electric shock
or other injuries.
Do not insert the metal needle into heat
dissipation hole or clearance in respect of
injury caused by electric shock.
Do not put the product in water or damp
environment or close to other heat sources,
and do not put the inner boiler on the naked
fire.
Hold the plug rather than haul the power
cord to pull out the power plug.
Do not operate on the unstable platform
or cushions which could not receive heat
in respect of injury or fire caused by fallen
ironing brush.

PRODUCT VIEW

1. Iron Brush, 2. Hook, 3. Adjustable Hanger, 4. Snap Close, 5. Steam Conduit, 6. Connector, 7. Switch
8. Water Tank, 9. Machine Body, 10. Water Outlet
Product Accessories
The product SSI 2893 consists of the machine body (including water tank), ironing brush, hook for
ironing brush, adjustable hanger, support pole.
A. Iron Brush, B. Hook for iron brush, C. Hanger, D. Support Pole
PARAMETERS
Product type: SSI 2893G, SSI 2893P
Rated power: 1580W
Voltage: 220V-240V~50Hz
Steam pressure: 1.0bar
Steam flow: 38g/min (max)
Tank capacity: 2700ml
Executive standard: EN60335-1/ EN60335-2-85
Use the socket with rated voltage of 220-
240V separately from other electric
appliances, otherwise, fire may occur due
to heat.
Do not pull or plug the plug with wet hand
in respect of electric shock.
Keep away from the steam hole to avoid
burn.
Keep it away from the children or others
unable to operate.
Remove the dust on power plug at regular
intervals, otherwise, fire accident may
occur due to poor insulation.
Do not touch the hot part, especially the
surface of steam jet of ironing brush during
or after the operation.
Do use the attached power cord which shall
not be used for other equipment.
If not in use, pull the power plug out of the
socket to avoid electric shock, creepage
and fire arising from damages and
insulation ageing.
- 12 -