Sinbo SSI 2893G Manual De Instrucciones página 15

8. Hang the ironing brush on the hook for it.
Note: The dismounting is in a reverse order. (Put the machine body and all accessories in safe place
during installation and dismounting.)
PRODUCT OPERATIONS
Ironing:
1. Stand the machine assembled on flat and stable floor. Adjust the height
and spread range of the hanger as required and hang the clothes on it.
Ensure there is enough water in the water tank and the tank is located
properly. Plug the plug into the power socket, select the appropriate gear.
Let the machine preheat for about 40s, waiting for steam of ironing brush.
When the ironing brush shake or move from side to side, water bead may be appeared on the handle
of ironing brush ( Danger of scalding ).
2. Iron from the main part of clothes, hold the lower hem by hand gently to make the wrinkled part flat
and iron the rippled fibers out by the hot steam (as shown in Picture 2).
Picture 3
3. Press gently the metal panel of ironing brush on the clothes, move the brush up and down at such
a speed that the steam penetrates into the fibers appropriately for hot forming.
4. After ironing the main part, ironing the specific parts from up to down. When ironing the collar, you
may fold the whole collar back, hold one end of the collar by hand, move the ironing brush horizontally
and, during when, be careful of the hot steam (as shown in Picture 3).
5. When ironing the sleeves, pull the sleeves to straight and move the ironing brush along the sleeves
(as shown in Picture 4 and 5).
Picture 4 Picture 5
- 14 -