Ice And Water; Automatic Ice Maker - Kenmore 596.57002600 Guía De Uso Y Cuidado

Ocultar thumbs Ver también para 596.57002600:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Ice and Water

Automatic Ice Maker

Operating Instructions
• Confirm ice bin is in place and ice
maker sensor arm is down.
• After freezer section reaches
between 0° to 2° F (-17° to -16° C),
ice maker fills with water and begins operating. You
will have a complete harvest of ice approximately
every three hours.
• Allow approximately 24 hours after installation to
receive first harvest of ice.
• Discard ice created within first 12 hours of operation
to verify system is flushed of impurities.
• Stop ice production by raising ice maker sensor arm
until click is heard.
• Ice maker will remain in the OFF position until sensor
arm is pushed down.
• The first one or two batches will probably contain
undersized and irregular cubes because of air in the
supply line.
• When the ice cubes are ejected it is normal for
several cubes to be joined together at the ends. They
can easily be broken apart. The ice maker will
continue to make ice until the supply of ice cubes
raises the sensor arm, shutting the ice maker off.
• Certain sounds may accompany the various cycles of
the ice maker. The motor may have a slight hum, the
cubes will rattle as they fall into an empty storage
pan and the water valve may click or "buzz"
occasionally. These sounds are normal.
• If the ice is not used frequently, the ice cubes will
become cloudy, shrink, stick together and taste stale.
Empty the ice storage bin periodically and wash it in
lukewarm water. Be sure to dry the bin thoroughly
before replacing it.
18
All manuals and user guides at all-guides.com
• Beverages and foods should not be placed in the
• Turn off (sensor arm up) the ice maker when the
To Remove the Ice Bin:
• Pull it forward, away from the ice maker. To avoid the
To Install the Ice Bin:
• Push the ice bin back towards the ice maker. Turn
ice storage bin for quick chilling. These items can
block the sensor arm, causing the ice maker to
malfunction.
water supply is to be shut off for several hours.
ice maker dumping ice while the bin is removed, turn
the ice maker off by raising the sensor arm.
the ice maker on by lowering the sensor arm.
WARNING
To avoid personal injury or property damage,
observe the following:
• Do not place fingers or hands on the automatic
ice making mechanism while the refrigerator is
plugged in. This will help protect you from possible
injury. It will also prevent interference with moving
parts of the ejector mechanism and the heating
element that releases the cubes.
• Under certain rare circumstances, ice cubes may
be discolored, usually appearing with a green-
bluish hue. The cause of this unusual discoloration
can be a combination of factors such as certain
characteristics of local waters, household
plumbing and the accumulation of copper salts in
an inactive water supply line which feeds the ice
maker. Continued consumption of such
discolored ice cubes may be injurious to
health. If such discoloration is observed, discard
the ice cubes and contact your dealer to purchase
and install a water line filter.
• Water damage due to improper water connection
may cause mold/mildew growth.
• Clean up water and ice spills to avoid personal
injury and to prevent mold/mildew growth.

Publicidad

Tabla de contenido
loading

Tabla de contenido