Advice regarding the first wash cycle
EN
After the installation, remove the stoppers from the racks and
the retaining elastic elements from the upper rack
Water softener settings
Before starting the first wash cycle, set the hardness lev-
el of
the water from the mains supply.
First load the softener tank with water, then introduce about
1 kg of salt. It is perfectly normal for water to flow out.
As soon as this procedure is complete, run a wash cycle.
Only use salt that has been specifically designed for dish-
washers.
After the salt has been poured into the machine, the LOW
SALT indicator light
If the salt container is not filled, the water softener and the
heating element may be damaged as a result.
14
*
switches off.
The machine has a buzzer/set of tones
dishwasher model
to inform the user that a command has
been implemented: power on, cycle end etc. *
The symbols/indicator lights/LEDs on the control panel/
display may vary in colour and may have a flashing or fixed
light
*
The display
provides useful information concerning the
type of wash cycle, drying/wash-cycle phase, remaining time,
temperature etc etc.
*
Only available in selected models.
.