Filters And Maintenance; Grease Filters - NEFF D8250N1 Instrucciones De Uso

Operating procedure
Intensive setting:
Maximum power is obtained at the
intensive setting. It is only required for short
intervals.
❑ Keep pressing the + button until a
appears in the display.
❑ If the intensive setting is not cancelled by
hand, the fan will automatically switch
back to step after 10 minutes.
}
Fan follow-on:
❑ Press the
button.
The fan continues to run at step
minutes, and at the same time a dot
flashes in the display. After this period
the fan switches off automatically.
Lighting:
❑ Briefly press the
a button to switch the
light on and off.
❑ The light can be switched on at any
time, even though the fan is switched off.
10
All manuals and user guides at all-guides.com
ç
| for 10

Filters and maintenance

Grease filters:
Metal filters are used to trap the greasy
element of the vapours that develop
during cooking.
The filter mats are made from non-
combustible metal.
Caution:
As the filter becomes more and more
saturated with grease, not only does the
risk of it catching fire increase but the
efficiency of the extractor hood can also be
adversely affected.
Important:
By cleaning the metal grease filters at
appropriate intervals, the possibility of them
catching fire as a result of a build-up of heat
such as occurs when deep-fat frying or
roasting is taking place, is reduced.
Saturation indicator:
When the grease filter becomes saturated,
the display symbol lights up and a signal
#
sounds. The signal is switched off when the
fan is switched off. The grease filters should
be cleaned straight away.
Cleaning the metal grease filters:
❑ The filters can be cleaned in a
dishwasher. It is however possible that
they will become slightly discoloured.
Important:
Metal filters that are saturated with
grease should not be washed together
with other dishes etc.
❑ When cleaning the filters by hand, soak
them in hot soapy water first of all.
Then brush the filters clean, rinse them
thoroughly and leave the water to drain off.
Removing and inserting the metal grease
filters:
Warning: The halogen bulbs must be
switched off and cool.
1. Press the handles on the grease filters
downwards and fold the grease filters
down. Fig. 1.
2. Clean the filters.
3. Insert the clean filters back into the
hood.
#
4. Cancel the in the display.
❑ Press the 0 button twice in rapid
succession. A signal sounds and the
display symbol
#
goes out.