Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING THE "B" UNIT
Refer to Figures 5 and 6.
1. Turn chain catch bracket so front hole is in line with hole
in sleeve and fasten into place with screw provided.
2. Attach chain to the outside door. Hook the spring end
of the chain into bracket at bottom of outside door.
3. Thread chain through guard at bottom of sleeve, over
switch arm and through hole in chain catch. Pull door
closed and lock chain into catch.
4. Refer to Figure 7. Install motor and blade assembly with
motor leads towards receptacle in outlet box cover. Place
keyhole in motor bracket over mounting screws in tabs on
inside sleeve. Turn bracket so screws are in slots of
keyhole and tighten screws. Spin the blade to be certain
it turns freely and plug motor in.
5. Place grille so center hole is in line with hole of stud on
motor bracket. Insert thumbscrew and tighten securely.
6. Unhook the chain from catch and allow the door to
completely open. Cut chain to desired length and
attach pendant.
COMPLETING THE INSTALLATION
Caulk around the outside panel's flange to insure proper
weatherproofing of the unit.
Product specifications subject to change without notice.
FIGURE 4
4820 Red Bank Road, Cincinnati, Ohio 45227
Printed in U.S.A., Rev. 5/01, Part No. 89741
FIGURE 5
FIGURE 6
FIGURE 7
Publicidad
