g Operating Instruction
CARE AND ATTENTION
•
Place your scales on a hard, fl at surface will ensure
the greatest accuracy and repeatability.
•
Always weigh yourself on the same scales placed
on the same fl oor surface. Uneven fl oors may affect
the readings.
•
Always weigh yourself without clothing or footwear,
and before meals. The fi rst thing in the morning is the
best time.
•
Your scales round up or down to the nearest
100g/0.2lb/ ¼ lb. if you weigh yourself twice and get
two different readings, your weight lies between the
two readings.
•
When the scale is on, if you put it on the fl oor after
it resets zero, the scale will display "1,5kg" (this is
the weight of scale, the range is 1,4kg-2,5kg). Please
wait until it is off automatically, then turn It on again.
•
Clean your scale with a damp cloth but do not allow
water to get inside the scales. Do not use any
chemical cleaning agents.
•
Do not allow your scales to become saturated with
water as this can damage the electronics.
•
Do not store the scales in an upright position when
not in use as this will drain the batteries.
•
Remove the batteries if the scales are not going to be
used for a long period of time.
•
Treat your scales with care-it is a precision
instrument, do not drop of jump up or down on them.
Your new electronic personal scales have been designed
to accurately inicate your weight gain or loss over a
period of time and should give you many years of service
under normal use.
SPECIFICATIONS
•
Equipped with a High Precision "Strain-Gauge"
Sensor.
•
Capacity 150 kg (330lg/24st)
•
Division 100g/0.2lb/1/4 lb.
•
LCD Display
•
Automatic Zero Resetting
•
Automatic Switch off
•
Over load indicator
•
Low Battery Indicator
4
00092675man_cs_de_en_es_fr_hu_nl_pl_ru_sk_ro.indd Abs2:4-Abs2:5
00092675man_cs_de_en_es_fr_hu_nl_pl_ru_sk_ro.indd Abs2:4-Abs2:5
POWER SUPPLY
Included Lithium Battery (CR2032), please remove the
insulation sheet from the battery contacts before using.
Replace the batteries when the "Low Battery Indicator"
shows.
OPERATING INSTRUCTIONS
•
Step 1: Put the scales on a hard fl at surface (avoiding
carpets or any soft surfaces).
• Step 2: Switch on the scales by with a slight tap on
the glass platform near LCD display. Then wait a few
seconds, the following will appear:
NOTE: the scales will not work properly if you step on the
scales before if shows "
" or "
". If this happens
please start from the beginning of step 2.
•
Step 3: Gently step on the scales. Put your feet evenly
on the scales without moving and wait whilst the
scales compute weight. Your correct weigh will then
be displayed in the following way:
„unit key" = Use the Button „unit key" on the backside to
select a weight scale to use: Metric(kg), Pounds(lb), or
Stones(ST)
AUTOMATIC SWITCH OFF
When you step off the scales, it will automatically switch
off. (If no weighing is carried out while the zero is being
displayed, the scales will automatically switch them-
selves off after approximately 6 seconds.)
OVERLOAD INDICATOR
When the scales are overloaded (over 150kg/330lb/24st),
the following will appear on the screen: "
".
BATTERY CHANGE INDICATOR
When the batteries need replacing, the following will
appear on the screen: "
"
Please open the back board of the scales, then take the
batteries carefully out of the battery compartment. Please
push the metal sheet outwards by your fi nger nails or a
sharp instrument. The battery will pop out. Do not bend
the contact back while you do this, or they may break.
Dispose of the old batteries in a safe place! Do no place
on fi re!
Important notes:
•
Caution: do not step on the scales with wet feet or
when the surface is damp – danger of slipping.
•
You should protect the scales from impact, damp,
dust, chemicals and extreme variations in
temperature and keep it away from sources of heat
(ovens, heaters).
5
21.12.10 14:25
21.12.10 14:25