Installing The Anti-Tip-Brackets - Thermador T24UW925LS Guia De Instalacion

Installing the anti-tip-brackets

The appliance includes two anti-tip-brackets. If your cabinetry is not designed for the specific dimensions
of your appliance, or if you plan to use the appliance as a free-standing unit, you should use these
brackets to avoid your appliance tilting due to unbalanced overweight situations where the door is open
and several Wine Racks are pulled out.
WARNING
To avoid the appliance tilting due to unbalanced overweight do not pull out all the Wine Racks at the
same time. Always push the W ine Rack into the cabinet before pulling out another Wine Rack.
For free-standing use
1. Consider the distance necessary for the appliance to be flush with the front of your cabinetry. If
there is no cabinetry, put the unit close to the wall, then take the measurement of the space at the
back, between the unit and the wall.
2. Based on the measured distance between the back of the unit and the wall, bend the anti-tip
bracket (included with the unit) from the pointed lines to form a "step" with the same Distance
measured.
Anti-tip-bracket.
2 pieces.
Bend from here
And here
Adhesive foam
Resultant formed "step".
NOTE: The adhesive foam must be at the bottom of the
step, never on the reverse side.
Distance measured
Page | 13