Additional Information
Troubleshooting
Common
Symptom
Power doesnt turn on.
The unit doesnt operate.
Operation with the remote con-
trol isnt possible.
The unit does not operate cor-
rectly even when the appropriate
remote control buttons are
pressed.
There is no picture.
There is audio and video skip-
ping.
When the ignition switch is
turned ON (or turned to ACC),
the motor sounds.
Nothing is displayed.
All manuals and user guides at all-guides.com
Cause
Leads and connectors are incor-
rectly connected.
The fuse is blown.
Noise and other factors are causing
the built-in microprocessor to oper-
ate incorrectly.
The remote control operation mode
is incorrect.
Battery power is low.
The parking brake cord is not con-
nected.
The parking brake is not applied.
The unit is not firmly secured.
The unit is confirming whether a
disc is loaded or not.
The rear view camera is not con-
nected.
B. CAMERA is at incorrect setting.
Action (See)
Confirm once more that all connections are
correct.
Rectify the reason for the fuse blowing, then
replace the fuse. Be very sure to install the
correct fuse with the same rating.
Press RESET. (Page 4)
Switch to the correct remote control mode.
(Page 7)
Load new battery. (Page 5)
Connect a parking brake cord, and apply the
parking brake.
Connect a parking brake cord, and apply the
parking brake.
Secure the unit firmly.
This is a normal operation.
Connect a rear view camera.
Press V.ADJ to return to the source display
and then select the correct setting for B.
CAMERA. (Page 12)
Appendix
15
En